Inflatable plugs seal pipes from 35 to 4,200 mm and adapt to irregular bores. Used correctly, they are quick and safe.
Before you inflate
- Check that the pipe diameter is within the plug’s usage range.
- Clean the pipe: remove sharp debris, stones and burrs that could cut the rubber.
- Inspect the plug for cuts, bulges or damaged fittings.
- Position the plug fully inside the pipe, never partly outside it.
Inflating and holding
- Inflate only to the inflation pressure marked for the plug, using a gauge.
- Respect the maximum back pressure for that plug and pipe size.
- Restrain the plug where the back pressure requires it.
- Keep people out of the line of the pipe while the plug is under load.
After the job
Release the back pressure first, then deflate the plug slowly before removing it. Clean the plug, check it for damage and store it away from sunlight, heat and sharp objects.
This article is general guidance. Always follow your project specification and the manufacturer’s instructions.





































