The right compound decides how long a seal lasts. Most of our parts are made from four rubbers, each with clear strengths and limits.
The four rubbers at a glance
| Rubber | Best for | Avoid with | Typical service temperature |
|---|---|---|---|
| EPDM | Water, steam, weather, ozone, sunlight | Oils, fuels and hydrocarbons | About −40 to +120 °C |
| NBR (nitrile) | Oils, fuels, greases and hydrocarbons | Ozone and outdoor weathering, unless protected | About −30 to +100 °C |
| SBR | General-purpose parts, good abrasion resistance | Oils and strong weathering | About −40 to +80 °C |
| NR (natural rubber) | Strength, elasticity and resilience | Oils, ozone and sunlight | About −50 to +70 °C |
Temperature ranges are typical and depend on the exact formulation. We adjust each compound for its service.
How to choose
- Water mains, sewer joints and outdoor seals: usually EPDM.
- Oil, fuel and hydrocarbon service: usually NBR.
- Abrasion and general mechanical parts: SBR or NR.
- Vibration mounts and parts that must spring back: often NR.
Tell us the conditions, not just the material
The best compound comes from the real conditions: the fluid, temperature, pressure, outdoor exposure and how the part moves. Send us those details with your drawing or sample and we will propose the compound.
This article is general guidance. Always follow your project specification and the manufacturer’s instructions.





































