Home / Products / Mechanical test plugs
CRYSTAL® pipeline solutions
Mechanical test & isolation plugs.
Plugs for pressure testing and line isolation: hydrostatic, pneumatic and leak tests, from DN10 lines up to 80″ (2000 mm) from stock, and up to 120″ (3000 mm) made to order. Choose by pipe size, pressure and application.
7 products
✓ Fits your
✓ Fits your
✓ Fits your
✓ Fits your
✓ Fits your
✓ Fits your
High-pressure plug for testing pipe elbows and bends, up to 3,408 psig (235 barg).
- Size range
- 3/8″ – 48″ (DN10 – DN1200)
- Test pressure
- Up to 3,408 psig (235 barg)
- Material
- Carbon / stainless steel
We make plugs to custom sizes and pressure ratings. Send us the pipe I.D. and test pressure.
Ask our engineersPlug selector
Not sure which plug? Let us narrow it down.
Pick the job, your pipe size and the pressure. We show every GRF plug that covers it, across all categories.
Coverage map
Every plug, size × pressure.
Each box shows the pipe sizes and pressures a plug covers. Enter your size and pressure above and the red point shows where you are. Dashed boxes: pressure class only, exact rating on request.
Engineering terms
Speak the same language.
Filling the pipe with water and raising it to a set test pressure to prove strength and tightness.
Testing with air or gas at low pressure, common for drain and sewer lines.
Checking that a closed pipe section holds its pressure without loss over a set time.
The pressure acting on the plug from inside the line. The plug must hold it without moving.
The pressure applied during the test. barg means bar above atmospheric pressure.
IN-MAX™ seals on the pipe inner diameter, OUT-MAX™ on the outer diameter.
The standard size name of a pipe, close to its bore in millimetres.
Closing open pipe ends with a plug for the test instead of welding end caps on and cutting them off.
Not sure which plug fits?
Send the pipe I.D., material and test pressure. Our engineers confirm the right plug and lead time.





































